Directv rc34 remote manual

Step 1: Slide the mode switch to the TV position. Step 3: Using the number keys, enter 9 6 0. The green light under the TV position flashes twice. You now can change the input for your TV. To enable this feature, perform the following steps:. Step 2: Using the number keys, enter 9 9 3. The green light will flash twice. The green light will flash 4 times. Step 3: Using the number keys, enter 9 9 3. When you activate the RF feature of your remote control, you can control your DirecTV Receiver from anywhere in your home.

You do not need to be within the line of sight of your receiver to control it. If your receiver requires an external RF antenna, before activating the RF transmitter, locate the RF antenna included with your remote control and insert it into the RF remote antenna coaxial connector on the back of your DirecTV Receiver.

You can find the RID number on the back panel of your receiver, or inside the CAM access door next to the reset button. Step 5: Using the number keys, enter 9 6 1. Step 6: Press and release "Channel Up". Step 7: Using the number keys, enter the last 6 digits of the RID number.

Step 3: Using the number keys, enter 9 6 1. Step 4: Press and release "Channel Down". The RF transmitter on your remote control is now deactivated. To reset all the functions of the remote control to the factory defaults the original, out-of-the-box settings , follow these steps:.

Step 2: Using the number keys, enter 9 8 1. The green light will flash 4 times signaling that the remote has successfully reset itself to factory defaults. If the device is not responding check the batteries in the remote it may be that batteries are exhausted. Use the remote control's mode buttons to set the remote to the correct mode for the equipment.

Be sure to program the remote control to operate the other equipment as described on manual. To change the mode, press the button for the equipment you want to control.

The mode button lights for three seconds to show you've set the remote to that mode. Depending on how the remote is set up, the remote control may use UHF radio signals, IR signals, or both to control the receiver. However, only IR signals are used to control other equipment. IR signals travel short distances generally 20 feet or 7 meters they can go up to 40 feet, and cannot go through walls or other solid objects. Point the remote control directly at the equipment you want to control, with no objects to block the signal path.

This manual shows you how to program the remote control to operate a TV. The following section uses a different method to program the remote control to operate a TV or other equipment such as a DVD player or VCR, tuner, amplifier, audio receiver or a second TV.

You can program the remote control by either following the instructions in Programming Using Equipment Remote Code Tables, or the Scanning for Equipment Codes procedure. Denon Soundbar. Samsung Soundbar.